SunCharger 2410

Solar Charge Controller

WELCOME!!!!

Follow the steps below to learn more about the SunCharger 2410!

FIRST

Head over to About to understand what is going on and why!

SECOND

Check out Overview to understand more about the SunCharger 2410 and it's roll in life!

PROTOTYPE

In order to get started, I had to make a printed circuit board to keep contacts between components ultra short and keep away unwanted inductances (from length of wires) and noise in my signals. The purpose of this was for testing and is not part of the final product.

Below are pictures of the PCB.

Bottom left picture may look funny but remember that I was designing this for high currents so I added traces with the leads from components and soldered them down onto the polygons.

THIRD

Roll on to Schematics to see my design of the SunCharger 2410!

FOURTH

Take a look at Datasheets to know more about the parts used!

FINALLY

Dive deeper with Deep to see how and why I used the parts I did!

THANK-YOU

I hope you enjoyed your time! If you ever get bored, start back up top with the first step again and embark on another... but similar, journey!

NOTE

Yet to add information on coding, final product pictures, "deep" stuff, final PowerPoint, final user's manual, charging of batteries and any other finishing touches!